Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. Brumley Roofing & Maintenance — leak-free skylight installation in Brumley.
We install deck-mounted skylights and curb-mounted skylights. Deck-mounted units sit flush against the roof deck and work best for shingle roofs on standard pitch. Curb-mounted units sit on a raised frame and work on flat or low-slope roofs. Both types get the same flashing treatment: ice-and-water shield, step flashing, counter-flashing, and sealant at every transition.
Our Skylight Installation Process
Skylight Planning
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Curb Construction
Roof deck opening cut to exact dimensions. Structural curb built between rafters with doubled headers for load transfer. This is the foundation that holds the skylight and carries snow load — it's built to structural standards.
Flashing & Waterproofing
Ice-and-water shield wrapped around the entire curb perimeter. Step flashing installed on all four sides, woven into the shingle courses. Counter-flashing at the top integrates with the shingles above. Sealant at every transition point. This flashing system is what prevents leaks — it's the most critical step.
Final Seal & Trim
Skylight unit set into the curb and flange sealed to the roof deck. Shingles re-laid around the unit with proper overlap. Inside, rigid insulation installed around the light shaft to prevent condensation. Interior trim finished. Watertight verified from the attic.
What Brumley Customers Say
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"Best experience we've ever had with a home service company. On time, on budget, and the results exceeded what we expected. Truly top-notch."
"Our neighbors recommended them and now we understand why. Meticulous attention to detail and they treated our home like it was their own."
Why Choose Brumley Roofing & Maintenance for Skylight Installation?
Roofer-Installed, Not Handyman
Brumley Roofing & Maintenance is a roofing contractor, not a general handyman. Skylights are roof penetrations — they require roofing expertise, proper flashing materials, and waterproofing knowledge. That's what we do every day.
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Code Compliant
Every skylight installation meets MO building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.